Crossover PCB for the VBS-10.2 DIY speaker design

Description: Custom printed circuit boards designed for the crossover of the VBS-10.2 DIY speaker design. Take the guesswork out of crossover assembly, these boards make the assembly process quick and straightforward. The boards measure 7" x 6.5" and features large solder pads and copper traces for great electrical connectivity Includes: 1x Crossover PCB for the VBS-10.2 speaker design. 3x Terminal blocks which accept up to 12 gauge wire. 4x Snap in PCB standoffs. 4x Mounting screws (screw finish may vary). Requires: Crossover components for the VBS-10.2 speaker design. Compatible components tested for fit on this PCB: C1 - 22uF - 100V Electrolytic Non-Polar Capacitor 22uF C3 - 17uF - 100V Electrolytic Non-Polar Capacitor 17uF C4 - 6.8uF - 100V Electrolytic Non-Polar Capacitor 6.8uF C5 - 3.0uF - Dayton Audio DPMC-3.0 C6 - 10uF - Dayton Audio DPMC-10 C7 - 12uF - Dayton Audio DPMC-12 L1 - 3.0mH - Dayton Audio 3.0mH 18 AWG I-Core -or- Erse Audio 3.0mH 18 AWG I-Core L2 - 2.5mH - Dayton Audio 2.5mH 18 AWG I-Core -or- Erse Audio 2.5mH 18 AWG I-Core L3 - 6.0mH - Dayton Audio 6.0mH 18 AWG I-Core -or- Erse Audio 6.0mH 18 AWG I-Core L4 - 1.5mH - Dayton Audio 1.5mH 20 AWG Air Core L6 - 0.15mH - Dayton Audio 0.15mH 20 AWG Air Core R1 - 15 Ohm - 10W wire wound resistor R2 - 2 Ohm - 10W wire wound resistor R3 - 10 Ohm - 10W wire wound resistor R4 - 5 Ohm - 10W wire wound resistor R5 - 12.5 Ohm - 10W wire wound resistor Assembly: Glue components to the correct positions on the board (hot melt glue works great). Secure inductors with non metallic cable ties. Solder components leads to the pads on the bottom of the board. Attach wires from input and drivers and mount crossover board.

Price: 15 USD

Location: Millbrook, Illinois

End Time: 2024-03-01T01:17:16.000Z

Shipping Cost: N/A USD